| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
f2fs: assign CURSEG_ALL_DATA_ATGC if blkaddr is valid
mkdir /mnt/test/comp
f2fs_io setflags compression /mnt/test/comp
dd if=/dev/zero of=/mnt/test/comp/testfile bs=16k count=1
truncate --size 13 /mnt/test/comp/testfile
In the above scenario, we can get a BUG_ON.
kernel BUG at fs/f2fs/segment.c:3589!
Call Trace:
do_write_page+0x78/0x390 [f2fs]
f2fs_outplace_write_data+0x62/0xb0 [f2fs]
f2fs_do_write_data_page+0x275/0x740 [f2fs]
f2fs_write_single_data_page+0x1dc/0x8f0 [f2fs]
f2fs_write_multi_pages+0x1e5/0xae0 [f2fs]
f2fs_write_cache_pages+0xab1/0xc60 [f2fs]
f2fs_write_data_pages+0x2d8/0x330 [f2fs]
do_writepages+0xcf/0x270
__writeback_single_inode+0x44/0x350
writeback_sb_inodes+0x242/0x530
__writeback_inodes_wb+0x54/0xf0
wb_writeback+0x192/0x310
wb_workfn+0x30d/0x400
The reason is we gave CURSEG_ALL_DATA_ATGC to COMPR_ADDR where the
page was set the gcing flag by set_cluster_dirty(). |
| In the Linux kernel, the following vulnerability has been resolved:
net, sunrpc: Remap EPERM in case of connection failure in xs_tcp_setup_socket
When using a BPF program on kernel_connect(), the call can return -EPERM. This
causes xs_tcp_setup_socket() to loop forever, filling up the syslog and causing
the kernel to potentially freeze up.
Neil suggested:
This will propagate -EPERM up into other layers which might not be ready
to handle it. It might be safer to map EPERM to an error we would be more
likely to expect from the network system - such as ECONNREFUSED or ENETDOWN.
ECONNREFUSED as error seems reasonable. For programs setting a different error
can be out of reach (see handling in 4fbac77d2d09) in particular on kernels
which do not have f10d05966196 ("bpf: Make BPF_PROG_RUN_ARRAY return -err
instead of allow boolean"), thus given that it is better to simply remap for
consistent behavior. UDP does handle EPERM in xs_udp_send_request(). |
| In the Linux kernel, the following vulnerability has been resolved:
x86/bhi: Avoid warning in #DB handler due to BHI mitigation
When BHI mitigation is enabled, if SYSENTER is invoked with the TF flag set
then entry_SYSENTER_compat() uses CLEAR_BRANCH_HISTORY and calls the
clear_bhb_loop() before the TF flag is cleared. This causes the #DB handler
(exc_debug_kernel()) to issue a warning because single-step is used outside the
entry_SYSENTER_compat() function.
To address this issue, entry_SYSENTER_compat() should use CLEAR_BRANCH_HISTORY
after making sure the TF flag is cleared.
The problem can be reproduced with the following sequence:
$ cat sysenter_step.c
int main()
{ asm("pushf; pop %ax; bts $8,%ax; push %ax; popf; sysenter"); }
$ gcc -o sysenter_step sysenter_step.c
$ ./sysenter_step
Segmentation fault (core dumped)
The program is expected to crash, and the #DB handler will issue a warning.
Kernel log:
WARNING: CPU: 27 PID: 7000 at arch/x86/kernel/traps.c:1009 exc_debug_kernel+0xd2/0x160
...
RIP: 0010:exc_debug_kernel+0xd2/0x160
...
Call Trace:
<#DB>
? show_regs+0x68/0x80
? __warn+0x8c/0x140
? exc_debug_kernel+0xd2/0x160
? report_bug+0x175/0x1a0
? handle_bug+0x44/0x90
? exc_invalid_op+0x1c/0x70
? asm_exc_invalid_op+0x1f/0x30
? exc_debug_kernel+0xd2/0x160
exc_debug+0x43/0x50
asm_exc_debug+0x1e/0x40
RIP: 0010:clear_bhb_loop+0x0/0xb0
...
</#DB>
<TASK>
? entry_SYSENTER_compat_after_hwframe+0x6e/0x8d
</TASK>
[ bp: Massage commit message. ] |
| In the Linux kernel, the following vulnerability has been resolved:
firmware: cs_dsp: Validate payload length before processing block
Move the payload length check in cs_dsp_load() and cs_dsp_coeff_load()
to be done before the block is processed.
The check that the length of a block payload does not exceed the number
of remaining bytes in the firwmware file buffer was being done near the
end of the loop iteration. However, some code before that check used the
length field without validating it. |
| In the Linux kernel, the following vulnerability has been resolved:
usb: dwc3: core: remove lock of otg mode during gadget suspend/resume to avoid deadlock
When config CONFIG_USB_DWC3_DUAL_ROLE is selected, and trigger system
to enter suspend status with below command:
echo mem > /sys/power/state
There will be a deadlock issue occurring. Detailed invoking path as
below:
dwc3_suspend_common()
spin_lock_irqsave(&dwc->lock, flags); <-- 1st
dwc3_gadget_suspend(dwc);
dwc3_gadget_soft_disconnect(dwc);
spin_lock_irqsave(&dwc->lock, flags); <-- 2nd
This issue is exposed by commit c7ebd8149ee5 ("usb: dwc3: gadget: Fix
NULL pointer dereference in dwc3_gadget_suspend") that removes the code
of checking whether dwc->gadget_driver is NULL or not. It causes the
following code is executed and deadlock occurs when trying to get the
spinlock. In fact, the root cause is the commit 5265397f9442("usb: dwc3:
Remove DWC3 locking during gadget suspend/resume") that forgot to remove
the lock of otg mode. So, remove the redundant lock of otg mode during
gadget suspend/resume. |
| In the Linux kernel, the following vulnerability has been resolved:
can: mcp251xfd: fix infinite loop when xmit fails
When the mcp251xfd_start_xmit() function fails, the driver stops
processing messages, and the interrupt routine does not return,
running indefinitely even after killing the running application.
Error messages:
[ 441.298819] mcp251xfd spi2.0 can0: ERROR in mcp251xfd_start_xmit: -16
[ 441.306498] mcp251xfd spi2.0 can0: Transmit Event FIFO buffer not empty. (seq=0x000017c7, tef_tail=0x000017cf, tef_head=0x000017d0, tx_head=0x000017d3).
... and repeat forever.
The issue can be triggered when multiple devices share the same SPI
interface. And there is concurrent access to the bus.
The problem occurs because tx_ring->head increments even if
mcp251xfd_start_xmit() fails. Consequently, the driver skips one TX
package while still expecting a response in
mcp251xfd_handle_tefif_one().
Resolve the issue by starting a workqueue to write the tx obj
synchronously if err = -EBUSY. In case of another error, decrement
tx_ring->head, remove skb from the echo stack, and drop the message.
[mkl: use more imperative wording in patch description] |
| In the Linux kernel, the following vulnerability has been resolved:
io_uring: fix possible deadlock in io_register_iowq_max_workers()
The io_register_iowq_max_workers() function calls io_put_sq_data(),
which acquires the sqd->lock without releasing the uring_lock.
Similar to the commit 009ad9f0c6ee ("io_uring: drop ctx->uring_lock
before acquiring sqd->lock"), this can lead to a potential deadlock
situation.
To resolve this issue, the uring_lock is released before calling
io_put_sq_data(), and then it is re-acquired after the function call.
This change ensures that the locks are acquired in the correct
order, preventing the possibility of a deadlock. |
| In the Linux kernel, the following vulnerability has been resolved:
net: ks8851: Fix deadlock with the SPI chip variant
When SMP is enabled and spinlocks are actually functional then there is
a deadlock with the 'statelock' spinlock between ks8851_start_xmit_spi
and ks8851_irq:
watchdog: BUG: soft lockup - CPU#0 stuck for 27s!
call trace:
queued_spin_lock_slowpath+0x100/0x284
do_raw_spin_lock+0x34/0x44
ks8851_start_xmit_spi+0x30/0xb8
ks8851_start_xmit+0x14/0x20
netdev_start_xmit+0x40/0x6c
dev_hard_start_xmit+0x6c/0xbc
sch_direct_xmit+0xa4/0x22c
__qdisc_run+0x138/0x3fc
qdisc_run+0x24/0x3c
net_tx_action+0xf8/0x130
handle_softirqs+0x1ac/0x1f0
__do_softirq+0x14/0x20
____do_softirq+0x10/0x1c
call_on_irq_stack+0x3c/0x58
do_softirq_own_stack+0x1c/0x28
__irq_exit_rcu+0x54/0x9c
irq_exit_rcu+0x10/0x1c
el1_interrupt+0x38/0x50
el1h_64_irq_handler+0x18/0x24
el1h_64_irq+0x64/0x68
__netif_schedule+0x6c/0x80
netif_tx_wake_queue+0x38/0x48
ks8851_irq+0xb8/0x2c8
irq_thread_fn+0x2c/0x74
irq_thread+0x10c/0x1b0
kthread+0xc8/0xd8
ret_from_fork+0x10/0x20
This issue has not been identified earlier because tests were done on
a device with SMP disabled and so spinlocks were actually NOPs.
Now use spin_(un)lock_bh for TX queue related locking to avoid execution
of softirq work synchronously that would lead to a deadlock. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7921s: fix potential hung tasks during chip recovery
During chip recovery (e.g. chip reset), there is a possible situation that
kernel worker reset_work is holding the lock and waiting for kernel thread
stat_worker to be parked, while stat_worker is waiting for the release of
the same lock.
It causes a deadlock resulting in the dumping of hung tasks messages and
possible rebooting of the device.
This patch prevents the execution of stat_worker during the chip recovery. |
| In the Linux kernel, the following vulnerability has been resolved:
net: fec: remove .ndo_poll_controller to avoid deadlocks
There is a deadlock issue found in sungem driver, please refer to the
commit ac0a230f719b ("eth: sungem: remove .ndo_poll_controller to avoid
deadlocks"). The root cause of the issue is that netpoll is in atomic
context and disable_irq() is called by .ndo_poll_controller interface
of sungem driver, however, disable_irq() might sleep. After analyzing
the implementation of fec_poll_controller(), the fec driver should have
the same issue. Due to the fec driver uses NAPI for TX completions, the
.ndo_poll_controller is unnecessary to be implemented in the fec driver,
so fec_poll_controller() can be safely removed. |
| XRA dissector infinite loop in Wireshark 4.0.0 to 4.0.5 and 3.6.0 to 3.6.13 allows denial of service via packet injection or crafted capture file |
| GDSDB infinite loop in Wireshark 4.0.0 to 4.0.5 and 3.6.0 to 3.6.13 allows denial of service via packet injection or crafted capture file |
| LISP dissector large loop in Wireshark 4.0.0 to 4.0.4 and 3.6.0 to 3.6.12 allows denial of service via packet injection or crafted capture file |
| Excessive loops in multiple dissectors in Wireshark 4.0.0 to 4.0.2 and 3.6.0 to 3.6.10 and allows denial of service via packet injection or crafted capture file |
| Infinite loops in the BPv6, OpenFlow, and Kafka protocol dissectors in Wireshark 4.0.0 to 4.0.1 and 3.6.0 to 3.6.9 allows denial of service via packet injection or crafted capture file |
| Infinite loop in the F5 Ethernet Trailer protocol dissector in Wireshark 3.6.0 to 3.6.7 and 3.4.0 to 3.4.15 allows denial of service via packet injection or crafted capture file |
| Infinite loop in RTMPT protocol dissector in Wireshark 3.6.0 to 3.6.1 and 3.4.0 to 3.4.11 allows denial of service via packet injection or crafted capture file |
| Large loops in multiple protocol dissectors in Wireshark 3.6.0 to 3.6.1 and 3.4.0 to 3.4.11 allow denial of service via packet injection or crafted capture file |
| Large loop in the Kafka dissector in Wireshark 3.6.0 allows denial of service via packet injection or crafted capture file |
| Infinite loop in the RTMPT dissector in Wireshark 3.6.0 and 3.4.0 to 3.4.10 allows denial of service via packet injection or crafted capture file |
