| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
usb: dwc2: gadget: Fix spin_lock/unlock mismatch in dwc2_hsotg_udc_stop()
dwc2_gadget_exit_clock_gating() internally calls call_gadget() macro,
which expects hsotg->lock to be held since it does spin_unlock/spin_lock
around the gadget driver callback invocation.
However, dwc2_hsotg_udc_stop() calls dwc2_gadget_exit_clock_gating()
without holding the lock. This leads to:
- spin_unlock on a lock that is not held (undefined behavior)
- The lock remaining held after dwc2_gadget_exit_clock_gating() returns,
causing a deadlock when spin_lock_irqsave() is called later in the
same function.
Fix this by acquiring hsotg->lock before calling
dwc2_gadget_exit_clock_gating() and releasing it afterwards, which
satisfies the locking requirement of the call_gadget() macro. |
| In the Linux kernel, the following vulnerability has been resolved:
ntfs3: fix circular locking dependency in run_unpack_ex
Syzbot reported a circular locking dependency between wnd->rw_lock
(sbi->used.bitmap) and ni->file.run_lock.
The deadlock scenario:
1. ntfs_extend_mft() takes ni->file.run_lock then wnd->rw_lock.
2. run_unpack_ex() takes wnd->rw_lock then tries to acquire
ni->file.run_lock inside ntfs_refresh_zone().
This creates an AB-BA deadlock.
Fix this by using down_read_trylock() instead of down_read() when
acquiring run_lock in run_unpack_ex(). If the lock is contended,
skip ntfs_refresh_zone() - the MFT zone will be refreshed on the
next MFT operation. This breaks the circular dependency since we
never block waiting for run_lock while holding wnd->rw_lock. |
| In the Linux kernel, the following vulnerability has been resolved:
ext4: avoid infinite loops caused by residual data
On the mkdir/mknod path, when mapping logical blocks to physical blocks,
if inserting a new extent into the extent tree fails (in this example,
because the file system disabled the huge file feature when marking the
inode as dirty), ext4_ext_map_blocks() only calls ext4_free_blocks() to
reclaim the physical block without deleting the corresponding data in
the extent tree. This causes subsequent mkdir operations to reference
the previously reclaimed physical block number again, even though this
physical block is already being used by the xattr block. Therefore, a
situation arises where both the directory and xattr are using the same
buffer head block in memory simultaneously.
The above causes ext4_xattr_block_set() to enter an infinite loop about
"inserted" and cannot release the inode lock, ultimately leading to the
143s blocking problem mentioned in [1].
If the metadata is corrupted, then trying to remove some extent space
can do even more harm. Also in case EXT4_GET_BLOCKS_DELALLOC_RESERVE
was passed, remove space wrongly update quota information.
Jan Kara suggests distinguishing between two cases:
1) The error is ENOSPC or EDQUOT - in this case the filesystem is fully
consistent and we must maintain its consistency including all the
accounting. However these errors can happen only early before we've
inserted the extent into the extent tree. So current code works correctly
for this case.
2) Some other error - this means metadata is corrupted. We should strive to
do as few modifications as possible to limit damage. So I'd just skip
freeing of allocated blocks.
[1]
INFO: task syz.0.17:5995 blocked for more than 143 seconds.
Call Trace:
inode_lock_nested include/linux/fs.h:1073 [inline]
__start_dirop fs/namei.c:2923 [inline]
start_dirop fs/namei.c:2934 [inline] |
| In the Linux kernel, the following vulnerability has been resolved:
writeback: don't block sync for filesystems with no data integrity guarantees
Add a SB_I_NO_DATA_INTEGRITY superblock flag for filesystems that cannot
guarantee data persistence on sync (eg fuse). For superblocks with this
flag set, sync kicks off writeback of dirty inodes but does not wait
for the flusher threads to complete the writeback.
This replaces the per-inode AS_NO_DATA_INTEGRITY mapping flag added in
commit f9a49aa302a0 ("fs/writeback: skip AS_NO_DATA_INTEGRITY mappings
in wait_sb_inodes()"). The flag belongs at the superblock level because
data integrity is a filesystem-wide property, not a per-inode one.
Having this flag at the superblock level also allows us to skip having
to iterate every dirty inode in wait_sb_inodes() only to skip each inode
individually.
Prior to this commit, mappings with no data integrity guarantees skipped
waiting on writeback completion but still waited on the flusher threads
to finish initiating the writeback. Waiting on the flusher threads is
unnecessary. This commit kicks off writeback but does not wait on the
flusher threads. This change properly addresses a recent report [1] for
a suspend-to-RAM hang seen on fuse-overlayfs that was caused by waiting
on the flusher threads to finish:
Workqueue: pm_fs_sync pm_fs_sync_work_fn
Call Trace:
<TASK>
__schedule+0x457/0x1720
schedule+0x27/0xd0
wb_wait_for_completion+0x97/0xe0
sync_inodes_sb+0xf8/0x2e0
__iterate_supers+0xdc/0x160
ksys_sync+0x43/0xb0
pm_fs_sync_work_fn+0x17/0xa0
process_one_work+0x193/0x350
worker_thread+0x1a1/0x310
kthread+0xfc/0x240
ret_from_fork+0x243/0x280
ret_from_fork_asm+0x1a/0x30
</TASK>
On fuse this is problematic because there are paths that may cause the
flusher thread to block (eg if systemd freezes the user session cgroups
first, which freezes the fuse daemon, before invoking the kernel
suspend. The kernel suspend triggers ->write_node() which on fuse issues
a synchronous setattr request, which cannot be processed since the
daemon is frozen. Or if the daemon is buggy and cannot properly complete
writeback, initiating writeback on a dirty folio already under writeback
leads to writeback_get_folio() -> folio_prepare_writeback() ->
unconditional wait on writeback to finish, which will cause a hang).
This commit restores fuse to its prior behavior before tmp folios were
removed, where sync was essentially a no-op.
[1] https://lore.kernel.org/linux-fsdevel/CAJnrk1a-asuvfrbKXbEwwDSctvemF+6zfhdnuzO65Pt8HsFSRw@mail.gmail.com/T/#m632c4648e9cafc4239299887109ebd880ac6c5c1 |
| Tor before 0.4.9.7, when circuit queue memory pressure exists, can experience a client crash because of a double close of a circuit, aka TROVE-2026-009. |
| In the Linux kernel, the following vulnerability has been resolved:
igb: remove napi_synchronize() in igb_down()
When an AF_XDP zero-copy application terminates abruptly (e.g., kill -9),
the XSK buffer pool is destroyed but NAPI polling continues.
igb_clean_rx_irq_zc() repeatedly returns the full budget, preventing
napi_complete_done() from clearing NAPI_STATE_SCHED.
igb_down() calls napi_synchronize() before napi_disable() for each queue
vector. napi_synchronize() spins waiting for NAPI_STATE_SCHED to clear,
which never happens. igb_down() blocks indefinitely, the TX watchdog
fires, and the TX queue remains permanently stalled.
napi_disable() already handles this correctly: it sets NAPI_STATE_DISABLE.
After a full-budget poll, __napi_poll() checks napi_disable_pending(). If
set, it forces completion and clears NAPI_STATE_SCHED, breaking the loop
that napi_synchronize() cannot.
napi_synchronize() was added in commit 41f149a285da ("igb: Fix possible
panic caused by Rx traffic arrival while interface is down").
napi_disable() provides stronger guarantees: it prevents further
scheduling and waits for any active poll to exit.
Other Intel drivers (ixgbe, ice, i40e) use napi_disable() without a
preceding napi_synchronize() in their down paths.
Remove redundant napi_synchronize() call and reorder napi_disable()
before igb_set_queue_napi() so the queue-to-NAPI mapping is only
cleared after polling has fully stopped. |
| In the Linux kernel, the following vulnerability has been resolved:
gpio: omap: do not register driver in probe()
Commit 11a78b794496 ("ARM: OMAP: MPUIO wake updates") registers the
omap_mpuio_driver from omap_mpuio_init(), which is called from
omap_gpio_probe().
However, it neither makes sense to register drivers from probe()
callbacks of other drivers, nor does the driver core allow registering
drivers with a device lock already being held.
The latter was revealed by commit dc23806a7c47 ("driver core: enforce
device_lock for driver_match_device()") leading to a potential deadlock
condition described in [1].
Additionally, the omap_mpuio_driver is never unregistered from the
driver core, even if the module is unloaded.
Hence, register the omap_mpuio_driver from the module initcall and
unregister it in module_exit(). |
| Loop with unreachable exit condition ('infinite loop') in .NET, .NET Framework, Visual Studio allows an unauthorized attacker to deny service over a network. |
| PJSIP is a free and open source multimedia communication library written in the C language. Versions 2.12 and prior contain a denial-of-service vulnerability that affects PJSIP users that consume PJSIP's XML parsing in their apps. Users are advised to update. There are no known workarounds. |
| mutt before 2.3.2 has an infinite loop in data_object_to_stream in crypt-gpgme.c. |
| Spring MVC and WebFlux applications are vulnerable to cache poisoning when resolving static resources.
More precisely, an application can be vulnerable when all the following are true:
* the application is using Spring MVC or Spring WebFlux
* the application is configuring the resource chain support https://docs.spring.io/spring-framework/reference/web/webmvc/mvc-config/static-resources.html#page-title with caching enabled
* the application adds support for encoded resources resolution
* the resource cache must be empty when the attacker has access to the application
When all the conditions above are met, the attacker can send malicious requests and poison the resource cache with resources using the wrong encoding. This can cause a denial of service by breaking the front-end application for clients. |
| SANE protocol dissector infinite loop in Wireshark 4.6.0 to 4.6.4 and 4.4.0 to 4.4.14 allows denial of service |
| TLS protocol dissector infinite loop in Wireshark 4.6.0 to 4.6.4 allows denial of service |
| OpenFlow v5 protocol dissector infinite loops in Wireshark 4.6.0 to 4.6.4 and 4.4.0 to 4.4.14 allows denial of service |
| RPKI-Router protocol dissector infinite loop in Wireshark 4.6.0 to 4.6.4 and 4.4.0 to 4.4.14 allows denial of service |
| GNW protocol dissector infinite loop in Wireshark 4.6.0 to 4.6.4 and 4.4.0 to 4.4.14 allows denial of service |
| SMB2 protocol dissector infinite loop in Wireshark 4.6.0 to 4.6.4 and 4.4.0 to 4.4.14 allows denial of service |
| UDS protocol dissector infinite loop in Wireshark 4.6.0 to 4.6.4 and 4.4.0 to 4.4.14 allows denial of service |
| USB HID protocol dissector infinite loop in Wireshark 4.6.0 to 4.6.4 and 4.4.0 to 4.4.14 allows denial of service |
| DLMS/COSEM protocol dissector infinite loop in Wireshark 4.6.0 to 4.6.4 |
