| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
NFSD: Fix NFSv3 SETATTR/CREATE's handling of large file sizes
iattr::ia_size is a loff_t, so these NFSv3 procedures must be
careful to deal with incoming client size values that are larger
than s64_max without corrupting the value.
Silently capping the value results in storing a different value
than the client passed in which is unexpected behavior, so remove
the min_t() check in decode_sattr3().
Note that RFC 1813 permits only the WRITE procedure to return
NFS3ERR_FBIG. We believe that NFSv3 reference implementations
also return NFS3ERR_FBIG when ia_size is too large. |
| In the Linux kernel, the following vulnerability has been resolved:
NFSD: Fix ia_size underflow
iattr::ia_size is a loff_t, which is a signed 64-bit type. NFSv3 and
NFSv4 both define file size as an unsigned 64-bit type. Thus there
is a range of valid file size values an NFS client can send that is
already larger than Linux can handle.
Currently decode_fattr4() dumps a full u64 value into ia_size. If
that value happens to be larger than S64_MAX, then ia_size
underflows. I'm about to fix up the NFSv3 behavior as well, so let's
catch the underflow in the common code path: nfsd_setattr(). |
| In the Linux kernel, the following vulnerability has been resolved:
NFSD: Fix the behavior of READ near OFFSET_MAX
Dan Aloni reports:
> Due to commit 8cfb9015280d ("NFS: Always provide aligned buffers to
> the RPC read layers") on the client, a read of 0xfff is aligned up
> to server rsize of 0x1000.
>
> As a result, in a test where the server has a file of size
> 0x7fffffffffffffff, and the client tries to read from the offset
> 0x7ffffffffffff000, the read causes loff_t overflow in the server
> and it returns an NFS code of EINVAL to the client. The client as
> a result indefinitely retries the request.
The Linux NFS client does not handle NFS?ERR_INVAL, even though all
NFS specifications permit servers to return that status code for a
READ.
Instead of NFS?ERR_INVAL, have out-of-range READ requests succeed
and return a short result. Set the EOF flag in the result to prevent
the client from retrying the READ request. This behavior appears to
be consistent with Solaris NFS servers.
Note that NFSv3 and NFSv4 use u64 offset values on the wire. These
must be converted to loff_t internally before use -- an implicit
type cast is not adequate for this purpose. Otherwise VFS checks
against sb->s_maxbytes do not work properly. |
| The Linux kernel NFSD implementation prior to versions 5.19.17 and 6.0.2 are vulnerable to buffer overflow. NFSD tracks the number of pages held by each NFSD thread by combining the receive and send buffers of a remote procedure call (RPC) into a single array of pages. A client can force the send buffer to shrink by sending an RPC message over TCP with garbage data added at the end of the message. The RPC message with garbage data is still correctly formed according to the specification and is passed forward to handlers. Vulnerable code in NFSD is not expecting the oversized request and writes beyond the allocated buffer space. CVSS:3.1/AV:N/AC:L/PR:L/UI:N/S:U/C:N/I:N/A:H |
| A NULL pointer dereference vulnerability was found in vmwgfx driver in drivers/gpu/vmxgfx/vmxgfx_execbuf.c in GPU component of Linux kernel with device file '/dev/dri/renderD128 (or Dxxx)'. This flaw allows a local attacker with a user account on the system to gain privilege, causing a denial of service(DoS). |
| An out-of-bounds (OOB) memory write flaw was found in the NFSD in the Linux kernel. Missing sanity may lead to a write beyond bmval[bmlen-1] in nfsd4_decode_bitmap4 in fs/nfsd/nfs4xdr.c. In this flaw, a local attacker with user privilege may gain access to out-of-bounds memory, leading to a system integrity and confidentiality threat. |
| In the Linux kernel, the following vulnerability has been resolved:
nfsd: fix NULL dereference in nfs3svc_encode_getaclres
In error cases the dentry may be NULL.
Before 20798dfe249a, the encoder also checked dentry and
d_really_is_positive(dentry), but that looks like overkill to me--zero
status should be enough to guarantee a positive dentry.
This isn't the first time we've seen an error-case NULL dereference
hidden in the initialization of a local variable in an xdr encoder. But
I went back through the other recent rewrites and didn't spot any
similar bugs. |
| In the Linux kernel, the following vulnerability has been resolved:
NFSD: Fix READDIR buffer overflow
If a client sends a READDIR count argument that is too small (say,
zero), then the buffer size calculation in the new init_dirlist
helper functions results in an underflow, allowing the XDR stream
functions to write beyond the actual buffer.
This calculation has always been suspect. NFSD has never sanity-
checked the READDIR count argument, but the old entry encoders
managed the problem correctly.
With the commits below, entry encoding changed, exposing the
underflow to the pointer arithmetic in xdr_reserve_space().
Modern NFS clients attempt to retrieve as much data as possible
for each READDIR request. Also, we have no unit tests that
exercise the behavior of READDIR at the lower bound of @count
values. Thus this case was missed during testing. |
| In the Linux kernel, the following vulnerability has been resolved:
SUNRPC: Fix null pointer dereference in svc_rqst_free()
When alloc_pages_node() returns null in svc_rqst_alloc(), the
null rq_scratch_page pointer will be dereferenced when calling
put_page() in svc_rqst_free(). Fix it by adding a null check.
Addresses-Coverity: ("Dereference after null check") |
| fs/nfsd/trace.h in the Linux kernel before 5.13.4 might allow remote attackers to cause a denial of service (out-of-bounds read in strlen) by sending NFS traffic when the trace event framework is being used for nfsd. |
| In the Linux kernel, the following vulnerability has been resolved:
soc: qcom: pd-mapper: Fix element length in servreg_loc_pfr_req_ei
It looks element length declared in servreg_loc_pfr_req_ei for reason
not matching servreg_loc_pfr_req's reason field due which we could
observe decoding error on PD crash.
qmi_decode_string_elem: String len 81 >= Max Len 65
Fix this by matching with servreg_loc_pfr_req's reason field. |
| In the Linux kernel, the following vulnerability has been resolved:
media: v4l2-async: Fix error handling on steps after finding a match
Once an async connection is found to be matching with an fwnode, a
sub-device may be registered (in case it wasn't already), its bound
operation is called, ancillary links are created, the async connection
is added to the sub-device's list of connections and removed from the
global waiting connection list. Further on, the sub-device's possible own
notifier is searched for possible additional matches.
Fix these specific issues:
- If v4l2_async_match_notify() failed before the sub-notifier handling,
the async connection was unbound and its entry removed from the
sub-device's async connection list. The latter part was also done in
v4l2_async_match_notify().
- The async connection's sd field was only set after creating ancillary
links in v4l2_async_match_notify(). It was however dereferenced in
v4l2_async_unbind_subdev_one(), which was called on error path of
v4l2_async_match_notify() failure. |
| In the Linux kernel, the following vulnerability has been resolved:
spi: amlogic: spifc-a4: unregister ECC engine on probe failure and remove() callback
aml_sfc_probe() registers the on-host NAND ECC engine, but teardown was
missing from both probe unwind and remove-time cleanup. Add a devm cleanup
action after successful registration so
nand_ecc_unregister_on_host_hw_engine() runs automatically on probe
failures and during device removal. |
| In the Linux kernel, the following vulnerability has been resolved:
ceph: do not propagate page array emplacement errors as batch errors
When fscrypt is enabled, move_dirty_folio_in_page_array() may fail
because it needs to allocate bounce buffers to store the encrypted
versions of each folio. Each folio beyond the first allocates its bounce
buffer with GFP_NOWAIT. Failures are common (and expected) under this
allocation mode; they should flush (not abort) the batch.
However, ceph_process_folio_batch() uses the same `rc` variable for its
own return code and for capturing the return codes of its routine calls;
failing to reset `rc` back to 0 results in the error being propagated
out to the main writeback loop, which cannot actually tolerate any
errors here: once `ceph_wbc.pages` is allocated, it must be passed to
ceph_submit_write() to be freed. If it survives until the next iteration
(e.g. due to the goto being followed), ceph_allocate_page_array()'s
BUG_ON() will oops the worker.
Note that this failure mode is currently masked due to another bug
(addressed next in this series) that prevents multiple encrypted folios
from being selected for the same write.
For now, just reset `rc` when redirtying the folio to prevent errors in
move_dirty_folio_in_page_array() from propagating. Note that
move_dirty_folio_in_page_array() is careful never to return errors on
the first folio, so there is no need to check for that. After this
change, ceph_process_folio_batch() no longer returns errors; its only
remaining failure indicator is `locked_pages == 0`, which the caller
already handles correctly. |
| In the Linux kernel, the following vulnerability has been resolved:
ipv6: ioam: fix heap buffer overflow in __ioam6_fill_trace_data()
On the receive path, __ioam6_fill_trace_data() uses trace->nodelen
to decide how much data to write for each node. It trusts this field
as-is from the incoming packet, with no consistency check against
trace->type (the 24-bit field that tells which data items are
present). A crafted packet can set nodelen=0 while setting type bits
0-21, causing the function to write ~100 bytes past the allocated
region (into skb_shared_info), which corrupts adjacent heap memory
and leads to a kernel panic.
Add a shared helper ioam6_trace_compute_nodelen() in ioam6.c to
derive the expected nodelen from the type field, and use it:
- in ioam6_iptunnel.c (send path, existing validation) to replace
the open-coded computation;
- in exthdrs.c (receive path, ipv6_hop_ioam) to drop packets whose
nodelen is inconsistent with the type field, before any data is
written.
Per RFC 9197, bits 12-21 are each short (4-octet) fields, so they
are included in IOAM6_MASK_SHORT_FIELDS (changed from 0xff100000 to
0xff1ffc00). |
| In the Linux kernel, the following vulnerability has been resolved:
dm mpath: Add missing dm_put_device when failing to get scsi dh name
When commit fd81bc5cca8f ("scsi: device_handler: Return error pointer in
scsi_dh_attached_handler_name()") added code to fail parsing the path if
scsi_dh_attached_handler_name() failed with -ENOMEM, it didn't clean up
the reference to the path device that had just been taken. Fix this, and
steamline the error paths of parse_path() a little. |
| In the Linux kernel, the following vulnerability has been resolved:
nfsd: fix nfs4_file refcount leak in nfsd_get_dir_deleg()
Claude pointed out that there is a nfs4_file refcount leak in
nfsd_get_dir_deleg(). Ensure that the reference to "fp" is released
before returning. |
| In the Linux kernel, the following vulnerability has been resolved:
usb: image: mdc800: kill download URB on timeout
mdc800_device_read() submits download_urb and waits for completion.
If the timeout fires and the device has not responded, the function
returns without killing the URB, leaving it active.
A subsequent read() resubmits the same URB while it is still
in-flight, triggering the WARN in usb_submit_urb():
"URB submitted while active"
Check the return value of wait_event_timeout() and kill the URB if
it indicates timeout, ensuring the URB is complete before its status
is inspected or the URB is resubmitted.
Similar to
- commit 372c93131998 ("USB: yurex: fix control-URB timeout handling")
- commit b98d5000c505 ("media: rc: iguanair: handle timeouts") |
| In the Linux kernel, the following vulnerability has been resolved:
vhost: Take a reference on the task in struct vhost_task.
vhost_task_create() creates a task and keeps a reference to its
task_struct. That task may exit early via a signal and its task_struct
will be released.
A pending vhost_task_wake() will then attempt to wake the task and
access a task_struct which is no longer there.
Acquire a reference on the task_struct while creating the thread and
release the reference while the struct vhost_task itself is removed.
If the task exits early due to a signal, then the vhost_task_wake() will
still access a valid task_struct. The wake is safe and will be skipped
in this case. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/xe/vf: Don't expose sysfs attributes not applicable for VFs
VFs can't read BMG_PCIE_CAP(0x138340) register nor access PCODE
(already guarded by the info.skip_pcode flag) so we shouldn't
expose attributes that require any of them to avoid errors like:
[] xe 0000:03:00.1: [drm] Tile0: GT0: VF is trying to read an \
inaccessible register 0x138340+0x0
[] RIP: 0010:xe_gt_sriov_vf_read32+0x6c2/0x9a0 [xe]
[] Call Trace:
[] xe_mmio_read32+0x110/0x280 [xe]
[] auto_link_downgrade_capable_show+0x2e/0x70 [xe]
[] dev_attr_show+0x1a/0x70
[] sysfs_kf_seq_show+0xaa/0x120
[] kernfs_seq_show+0x41/0x60
(cherry picked from commit a2d6223d224f333f705ed8495bf8bebfbc585c35) |
