| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
fs/ntfs3: Fix some memory leaks in an error handling path of 'log_replay()'
All error handling paths lead to 'out' where many resources are freed.
Do it as well here instead of a direct return, otherwise 'log', 'ra' and
'log->one_page_buf' (at least) will leak. |
| In the Linux kernel, the following vulnerability has been resolved:
nfs: fix acl memory leak of posix_acl_create()
When looking into another nfs xfstests report, I found acl and
default_acl in nfs3_proc_create() and nfs3_proc_mknod() error
paths are possibly leaked. Fix them in advance. |
| In the Linux kernel, the following vulnerability has been resolved:
media: i2c/tw9906: Fix potential memory leak in tw9906_probe()
In one of the error paths in tw9906_probe(), the memory allocated in
v4l2_ctrl_handler_init() and v4l2_ctrl_new_std() is not freed. Fix that
by calling v4l2_ctrl_handler_free() on the handler in that error path. |
| In the Linux kernel, the following vulnerability has been resolved:
staging: rtl8723bs: fix memory leak on failure path
cfg80211_inform_bss_frame() may return NULL on failure. In that case,
the allocated buffer 'buf' is not freed and the function returns early,
leading to potential memory leak.
Fix this by ensuring that 'buf' is freed on both success and failure paths. |
| In the Linux kernel, the following vulnerability has been resolved:
media: pvrusb2: fix URB leak in pvr2_send_request_ex
When pvr2_send_request_ex() submits a write URB successfully but fails to
submit the read URB (e.g. returns -ENOMEM), it returns immediately without
waiting for the write URB to complete. Since the driver reuses the same
URB structure, a subsequent call to pvr2_send_request_ex() attempts to
submit the still-active write URB, triggering a 'URB submitted while
active' warning in usb_submit_urb().
Fix this by ensuring the write URB is unlinked and waited upon if the read
URB submission fails. |
| In the Linux kernel, the following vulnerability has been resolved:
io_uring/zcrx: fix sgtable leak on mapping failures
In an unlikely case when io_populate_area_dma() fails, which could only
happen on a PAGE_POOL_32BIT_ARCH_WITH_64BIT_DMA machine,
io_zcrx_map_area() will have an initialised and not freed table. It was
supposed to be cleaned up in the error path, but !is_mapped prevents
that. |
| In the Linux kernel, the following vulnerability has been resolved:
media: radio-keene: fix memory leak in error path
Fix a memory leak in usb_keene_probe(). The v4l2 control handler is
initialized and controls are added, but if v4l2_device_register() or
video_register_device() fails afterward, the handler was never freed,
leaking memory.
Add v4l2_ctrl_handler_free() call in the err_v4l2 error path to ensure
the control handler is properly freed for all error paths after it is
initialized. |
| In the Linux kernel, the following vulnerability has been resolved:
gfs2: fiemap page fault fix
In gfs2_fiemap(), we are calling iomap_fiemap() while holding the inode
glock. This can lead to recursive glock taking if the fiemap buffer is
memory mapped to the same inode and accessing it triggers a page fault.
Fix by disabling page faults for iomap_fiemap() and faulting in the
buffer by hand if necessary.
Fixes xfstest generic/742. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/atmel-hlcdc: fix memory leak from the atomic_destroy_state callback
After several commits, the slab memory increases. Some drm_crtc_commit
objects are not freed. The atomic_destroy_state callback only put the
framebuffer. Use the __drm_atomic_helper_plane_destroy_state() function
to put all the objects that are no longer needed.
It has been seen after hours of usage of a graphics application or using
kmemleak:
unreferenced object 0xc63a6580 (size 64):
comm "egt_basic", pid 171, jiffies 4294940784
hex dump (first 32 bytes):
40 50 34 c5 01 00 00 00 ff ff ff ff 8c 65 3a c6 @P4..........e:.
8c 65 3a c6 ff ff ff ff 98 65 3a c6 98 65 3a c6 .e:......e:..e:.
backtrace (crc c25aa925):
kmemleak_alloc+0x34/0x3c
__kmalloc_cache_noprof+0x150/0x1a4
drm_atomic_helper_setup_commit+0x1e8/0x7bc
drm_atomic_helper_commit+0x3c/0x15c
drm_atomic_commit+0xc0/0xf4
drm_atomic_helper_set_config+0x84/0xb8
drm_mode_setcrtc+0x32c/0x810
drm_ioctl+0x20c/0x488
sys_ioctl+0x14c/0xc20
ret_fast_syscall+0x0/0x54 |
| In the Linux kernel, the following vulnerability has been resolved:
net: qrtr: replace qrtr_tx_flow radix_tree with xarray to fix memory leak
__radix_tree_create() allocates and links intermediate nodes into the
tree one by one. If a subsequent allocation fails, the already-linked
nodes remain in the tree with no corresponding leaf entry. These orphaned
internal nodes are never reclaimed because radix_tree_for_each_slot()
only visits slots containing leaf values.
The radix_tree API is deprecated in favor of xarray. As suggested by
Matthew Wilcox, migrate qrtr_tx_flow from radix_tree to xarray instead
of fixing the radix_tree itself [1]. xarray properly handles cleanup of
internal nodes — xa_destroy() frees all internal xarray nodes when the
qrtr_node is released, preventing the leak.
[1] https://lore.kernel.org/all/20260225071623.41275-1-jiayuan.chen@linux.dev/T/ |
| In the Linux kernel, the following vulnerability has been resolved:
usb: misc: usbio: Fix URB memory leak on submit failure
When usb_submit_urb() fails in usbio_probe(), the previously allocated
URB is never freed, causing a memory leak.
Fix this by jumping to err_free_urb label to properly release the URB
on the error path. |
| In the Linux kernel, the following vulnerability has been resolved:
gpib: lpvo_usb: fix memory leak on disconnect
The driver iterates over the registered USB interfaces during GPIB
attach and takes a reference to their USB devices until a match is
found. These references are never released which leads to a memory leak
when devices are disconnected.
Fix the leak by dropping the unnecessary references. |
| In the Linux kernel, the following vulnerability has been resolved:
iio: gyro: mpu3050: Fix irq resource leak
The interrupt handler is setup but only a few lines down if
iio_trigger_register() fails the function returns without properly
releasing the handler.
Add cleanup goto to resolve resource leak.
Detected by Smatch:
drivers/iio/gyro/mpu3050-core.c:1128 mpu3050_trigger_probe() warn:
'irq' from request_threaded_irq() not released on lines: 1124. |
| In the Linux kernel, the following vulnerability has been resolved:
net: dsa: microchip: Fix error path in PTP IRQ setup
If request_threaded_irq() fails during the PTP message IRQ setup, the
newly created IRQ mapping is never disposed. Indeed, the
ksz_ptp_irq_setup()'s error path only frees the mappings that were
successfully set up.
Dispose the newly created mapping if the associated
request_threaded_irq() fails at setup. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_sync: fix leaks when hci_cmd_sync_queue_once fails
When hci_cmd_sync_queue_once() returns with error, the destroy callback
will not be called.
Fix leaking references / memory on these failures. |
| In the Linux kernel, the following vulnerability has been resolved:
net: ftgmac100: fix ring allocation unwind on open failure
ftgmac100_alloc_rings() allocates rx_skbs, tx_skbs, rxdes, txdes, and
rx_scratch in stages. On intermediate failures it returned -ENOMEM
directly, leaking resources allocated earlier in the function.
Rework the failure path to use staged local unwind labels and free
allocated resources in reverse order before returning -ENOMEM. This
matches common netdev allocation cleanup style. |
| In the Linux kernel, the following vulnerability has been resolved:
dmaengine: idxd: Fix leaking event log memory
During the device remove process, the device is reset, causing the
configuration registers to go back to their default state, which is
zero. As the driver is checking if the event log support was enabled
before deallocating, it will fail if a reset happened before.
Do not check if the support was enabled, the check for 'idxd->evl'
being valid (only allocated if the HW capability is available) is
enough. |
| In the Linux kernel, the following vulnerability has been resolved:
dmaengine: idxd: Fix memory leak when a wq is reset
idxd_wq_disable_cleanup() which is called from the reset path for a
workqueue, sets the wq type to NONE, which for other parts of the
driver mean that the wq is empty (all its resources were released).
Only set the wq type to NONE after its resources are released. |
| In the Linux kernel, the following vulnerability has been resolved:
s390/zcrypt: Fix memory leak with CCA cards used as accelerator
Tests showed that there is a memory leak if CCA cards are used as
accelerator for clear key RSA requests (ME and CRT). With the last
rework for the memory allocation the AP messages are allocated by
ap_init_apmsg() but for some reason on two places (ME and CRT) the
older allocation was still in place. So the first allocation simple
was never freed. |
| In the Linux kernel, the following vulnerability has been resolved:
comedi: runflags cannot determine whether to reclaim chanlist
syzbot reported a memory leak [1], because commit 4e1da516debb ("comedi:
Add reference counting for Comedi command handling") did not consider
the exceptional exit case in do_cmd_ioctl() where runflags is not set.
This caused chanlist not to be properly freed by do_become_nonbusy(),
as it only frees chanlist when runflags is correctly set.
Added a check in do_become_nonbusy() for the case where runflags is not
set, to properly free the chanlist memory.
[1]
BUG: memory leak
backtrace (crc 844a0efa):
__comedi_get_user_chanlist drivers/comedi/comedi_fops.c:1815 [inline]
do_cmd_ioctl.part.0+0x112/0x350 drivers/comedi/comedi_fops.c:1890
do_cmd_ioctl drivers/comedi/comedi_fops.c:1858 [inline] |
